Air filters protect your hvac system.
When we work in a dirty environment, we usually wear a mask to protect
our lungs. The filters in your hvac system have the same function. The
filter in your hvac system has two main functions. First it helps to
improve your home's indoor air quality.
This can improve the health of your
family. According to the U.S. EPA, the air inside your home can be 2 to 5
times worse than the air outside.
The second thing they do is to keep your
hvac system clean. If the dirt gets through the filter it can clog your
furnace's secondary heat exchanger. This can happen if you have a
condensing type furnace. If you don't have a condensing type furnace,
the dirt will collect on your ac unit's evaporator coil.
Either way, this restricts air flow.
This in turn can cause higher temperatures during heating system
operation and premature failure of parts. During cooling operation, the
operating efficiency will be reduced, your electric bills will go up,
and it will cause more wear and tear on system parts.
The filter is usually located in one of the following places:
1. In a grille in your wall or ceiling. These are commonly called return air filter grilles.
2. In a slot on the side, bottom or top of your furnace. It depends on the style of furnace you have.
3. Inside the blower compartment of the
furnace. This is common on older furnaces. Most manufacturers do not
recommend this on new furnaces.
Air filters have a standard rating. This
rating, minimum efficiency reporting value (MERV), is a number from
1-16. You don't have to know all the technical jargon. Simply put, as
the number goes up the unit will stop more and smaller particles.
If you decide to replace your existing
air filter with one of a higher MERV rating, you should check to make
sure you have sufficient airflow after you replace it. This is done by
checking the temperature rise in the heating mode and the temperature
drop in the cooling mode.
Many hvac units come with a washable type of filter. These will usually be made of foam. These have a merv rating of 1 to 4.
You can also use a disposable type which is normally made of fiberglass. These have a merv rating of 1 to 4.
Usually you can hold those types of filters up and see through them. If that is the case, you know they are not doing their job.
Another disposable type is the pleated
filter. These have a merv rating of 5 to 8. These products have more
surface area to catch the dirt. They also distribute the airflow more
evenly. This means the fan is less likely to pull the dirt through the
filter. This is the type of filter that we recommend for most
applications. They are the best value in terms of price for the filter
and keeping your hvac system clean.
Air filters with the higher MERV ratings are sometimes called allergy filters.
Some are made of advanced materials
which set up a static electrical charge. They are called electrostatic
filters and are able to capture much smaller particles.
Some come with an antimicrobial treatment. This prevents organisms from living on the filter when they are trapped.
Using the right air filter is only half
of the answer though. If it is not replaced often enough, your hvac
system operating efficiency will go down. This will cost you on your
utility bills as well as wear and tear on the hvac unit.
Most people, even those in the hvac
industry, don't change their filter as often as they should. It is
usually out of sight and out of mind.
Most hvac service companies offer
service contracts where they change your filter. These contracts can be
expensive when you consider you can do it yourself.
There are other options if you have
special needs such as allergies. The ultimate filter is called a high
efficiency particulate air filter(HEPA). These remove virtually
everything but the replacement elements can be expensive unless you shop
around.
You should also keep in mind that if the
filter is a part of the central hvac system and the fan is not
continuously running, then most of the time the filter will not be doing
anything.
No comments:
Post a Comment